Bass Butler Bi-Amp Bass Pre

Guitar and bass effects shopping guide

To consult

Contact an expert

Our musician and enthusiast tele-consultants are here to answer all your questions.

+33 181 930 900 email

Back in the good ol’ days, it was a popular practice to send a bass guitar signal to a bass amp and a guitar amp at the same time – known as Bi-Amping. This allows the player to keep their low end deep, clean and defined whilst amplifying the mids and top end separately, adding distortion or crisp highs with total control.
This type of setup can produce some enormous tones but typically requires a huge and complicated rig, only possible if you’re Rock ‘n’ Roll royalty.

The ORANGE Bass Butler Bi-Amp Bass Pre compact pedal features two completely separate, parallel, analogue signal chains, just like a real bi-amp rig. The difference is there’s not an amp in sight.

The always-on Bass Channel has a simple but effective control layout of Compression, Bass, Treble and Volume. An optical compressor circuit, cut/boost tone controls and dedicated, bass cabinet-simulated balanced D.I. output are always on hand with all manner of classic clean tones. From the depths of Dub to the heights of hi-fi, the Bass Butler has it all polished up and ready, like your best pair of shoes.

Whether you need mayhem, musicality or a mere modicum of mischief, this classic high-gain guitar channel won’t disappoint. Five familiar controls and four gain stages that can clean right up are summoned with one kick of the footswitch, serving up everything from bright vintage tones to floor-splitting, wall-crumbling modern destruction. Coupled with a guitar cab-simulated balanced D.I. output and an expression pedal jack for extra control over the input gain, this really is a plentiful platter, pleasing to the even pickiest of players.

The Bass Butler’s two individual XLR outputs from the two separate channels mean that your finished Bi-Amp bass tone makes it to the mixing desk with nothing left to do except blend to taste, with a Ground Lift switch for solving any ground loop issues. It’s the same story in the studio, but that’s not all…

The Bass Butler also features an Amp output, which takes a blend of the two channels before the cabinet simulation circuits from a 1/4” jack – perfect for connecting to the front end of any bass amp. The blend is set by the channel volume controls, meaning you can control your on-stage